Snipe Bolt and Pipe Extractors

link to Snipe Selection Table        

The Snipe Method

• The Snipe has blades that cut an edge or edges into the object to be removed.
  
  
  
• The Snipe's blades then use this driving edge to transfer the effort you use turning the wrench directly to removing the object
  
  
• All your energy goes into removing the object
  
  
• Turn until the object is out
  
  
• Tap the Snipe to release the tool from the object
  
  
• The Snipe is ready to be used again and again
  
  

Back to Top of Page

Select Snipe size after reviewing all information and instructions

Stock Selection Table

Use Proper Hand and Eye Protection When Using Snipe
Part #	Maximum Torque Values Ft/Lbs	Recommended Hole Size to be drilled into object to be removed		Recommend Bolt and Pipe Nipple Sizes
		Inch	MM	Bolt Size	SCH 40 NPT	SCH 80 NPT
SNIPE-1	20	7/32"	5.5	5/16"		1/8"
SNIPE-2	30	15/64"	6	3/8"	1/8"
SNIPE-3	60	5/16"	8	1/2"		1/4"
SNIPE-4	90	23/64"	9	5/8"	1/4"
SNIPE-5	120	7/16"	11	3/4"		3/8"
SNIPE-6	200	33/64"	13	7/8"	3/8"
SNIPE-7	250	35/64"	14	1"		1/2"
NOTE: A Pilot hole should be drilled to assure accurate hole size

Back to Top of Page