When conventional steel tools are used in potentially combustible
or explosive atmospheres, dangerous sparks may be accidental)
created by tools slipping or being struck against hard surfaces.
The only safe way to eliminate fires and explosions in hazardous
environments is to make sure that NO inflammable materials are
present when using metal hand tools. In practice this is rarely
possible and therefore plant managers and safety officers insist
that non-sparking tools are used for low-cost protection.
Ampco safety tools can provide a vital extra margin of safety
under these conditions. This margin could be crucial in protecting
personnel and installations from disaster.
For metallurgical reasons it is impossible to manufacture spark
resistant tools to the same hardness as high alloy steel, and
for this reason they must be handled and maintained with special
care. Frequent redressing to remove embedded particles of steel
or other substances which could cause sparks is essential. Abuse
must be avoided, e.g. extending handle length of wrenches with
piping or using air hammer tools as a crow bar.
Most of Ampco safety tools are available in aluminum bronze and
other special copper alloys. Most of the tools are beryllium-free.
Ampco Safety Tools are guaranteed against defects in it and workmanship.
Tools which fail because of abuse, intentional or unintentional,
or for any reason other than stated above cannot be replaced free
of charge.
We reserve the right to change design or dimensions without notice.
Back to Top of Page
Ampco is now offering a full range of beryllium
free products. Please contact us for more information
gnt byitfrom.com
